Table of Contents
Advertisement
40. CLEANING THE SOLUTION TANK FILTER - CAP
In order to ensure a proper flow of detergent solution into the water circuit, proper cleaning of the solution
tank filter is necessary. In order to do this, proceed as follows:
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions B-BT).
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions BB).
2. Disconnect the electrical connector (02) from the battery connector.
3. Engage the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
4. Loosen the solution tank filter cap (04).
5. Rinse the cap-filter carefully under running water.
6. Remove any impurities present in the moulded threaded bushing in the solution tank.
7. Reassemble all the elements.
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
41. CLEANING THE RECOVERY TANK FILTER
To ensure the correct function of the machine's vacuum motor, proper cleaning of the recovery tank filter
is necessary. In order to do this, proceed as follows::
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions B-BT).
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions BB).
DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
38
Advertisement
Table of Contents
