Table of Contents
Advertisement
WARNING: Carefully read the use and maintenance manual of the charger that is
delivered inside the bag containing this instruction booklet.
WARNING: Before inserting the charger power cable into the socket, verify that there
is no condensate or other forms of liquids.
WARNING: If the machine's electric system is accidentally powered, the command
display will show "BATTERY-CHARGER" and none of the steering wheel commands
will function (only for B-BT version).
15. When the recharge cycle is complete, disconnect the battery charger power supply cable from wall
plug.
16. Disconnect the battery charger cable connector from the plug (08) on the battery charger itself, and
insert in the storage drawer (09).
17. Replace the cap (07) on the battery charger plug.
15. BATTERY CHARGE LEVEL INDICATOR (B-BT VERSIONS)
On the instrument panel of the machine there is a monitor (1) indicating (amongst other things) the battery
charge status. If the lower line contains ten light indicators, the battery charge level is 100%. If the battery
charge percentage is at 00% and flashing, this means the batteries are discharged.
WARNING: a few seconds after the battery charge level reaches 20%, the brush
motor switches off automatically. With the remaining charge it is possible to complete
the drying process before starting the recharge.
WARNING: a few seconds after the battery charge level reaches 10%, the vacuum
motor switches off automatically. With the remaining charge, it is still possible,
however, to move the machine to the location designated for its recharging (only for
BT versions).
16. HOUR METER (B-BT VERSIONS)
On the machine's instrument panel there is a display (1) indicating the total machine usage time. The top
line shows the hours and minutes of functioning. The flashing ":" symbol Indicates that the hour meter is
counting the machine functioning time.
17. HOUR METER (BB VERSIONS)
The control display is on the rear of the appliance. The second screen that appears after it is switched on
shows the appliance's total usage time. The digits that precede the "." symbol identify hours, whilst the digit
that follows it indicates hour decimals (an hour decimal corresponds to six minutes). When the "hour glass"
symbol (1) is flashing it indicates that the hour meter is counting the appliance's operating time.
18. BATTERY CHARGE LEVEL INDICATOR (BB VERSIONS)
The control display is on the rear of the appliance. The graphic symbol that identifies the charge level of
batteries appears at the bottom of the control display. The indicator consists of charge level indicators. With
the minimum remaining charge is reached, the graphic symbol (2) will start to blink and will switch off after
a few seconds and then the symbol (3) will start to blink. Under these conditions, take the device to the
battery charge area.
ATTENTION: A few seconds after the battery charge level reaches the critical level (1),
the brush motor switches off automatically. With the remaining charge it is possible to
complete the drying process before starting the recharge.
ATTENTION: A few seconds after the battery charge level reaches the discharge level
(2), the vacuum motor switches off automatically.
MACHINE PREPARATION
22
Advertisement
Table of Contents
