Table of Contents
Advertisement
7. Remove the recovery tank drainage tube (01) and lay on the ground.
8. Remove the vacuum motor tube (05) from the connector present on the recovery tank.
9. Remove the squeegee vacuum hose (06) from the hole in the recovery tank.
10. Remove the vacuum cover and attach to the support designed for this purpose, positioned at the rear
of the machine.
11. Remove the recovery tank from the machine, taking care with the drainage hose, and rest on a raised
surface in order to avoid accidental damage.
WARNING: The shape of the recovery tanks means that it can be rested on the
ground with the rear part in contact with the floor, in order to avoid accidental damage
to the drainage joint.
12. Disconnect the electric system connector from the battery connector.
13. Connect the battery charger cable to the battery connector.
14. Connect the recently wired cable to the external battery charger
WARNING: Carefully read the use and maintenance instructions of the battery
charger that is used for charging.
WARNING: Keep the recovery tank open for the duration of the battery recharging
cycle to allow gas fumes to escape
WARNING: The room used to recharge the batteries must be adequately ventilated
to prevent the accumulation of gases that leak from batteries.
WARNING: Danger of gas exhalation and leakage of corrosive liquids.
WARNING: Danger of fire: Keep naked flames at a safe distance.
15. When the recharge cycle is complete, disconnect the battery charger connector from the battery
connector.
16. Connect the electrical system connector to the battery connector.
17. Position the recovery tank on the machine, ensuring the drainage tube is positioned correctly.
18. Fix the recovery tank drainage tube (01) at the rear of the machine.
19. Insert the vacuum motor tube (05) into the holder at the rear of the recovery tank.
20. Insert the squeegee vacuum hose (06) into the hole at the rear of the recovery tank.
MACHINE PREPARATION
20
Advertisement
Table of Contents
