Forward Work Speed (Bt Versions); Forward Work Speed (B-Bb Versions); Filling The Solution Tank - Ice MTECH 70 D Use And Maintenance Manual

Professional scrubbing machines

Table of Contents

19. FORWARD WORK SPEED (BT VERSIONS)

This machine is equipped with electronic traction control. To move the machine, after turning the key to

position "I" simply push the dead man's lever, located under the grip of the handlebar.

WARNING! The machine will not start to move (either forward or backward) if the

potentiometer adjustment knob (01) is set to minimum.

The traction of these machines is obtained by means of the brush which, working with the right weight

distribution, is able to drag the machine forwards.

WARNING! If the machine shows signs of directional imbalance, refer to the section

"ADJUSTING THE

Before filling the solution tank, carry out the following steps:

1. The recovery tank must be completely empty each time the solution tank is filled.

2. Check that the brush head and squeegee are resting on the ground; if not, carry out this step.

3. Check that the main switch is in the "0" position; if not turn the key a quarter turn to the left (for B-BT

version only), and remove the key from the instrument panel. Check that the machine's main switch at

the back of the machine is in the "0" position; if not, turn to "0" (for BB version only).

4. Engage the parking brake by means of the lever on the right side of the machine (only for BT versions).

5. Check that the solution filter cap (02), located on the left side of the machine, is properly closed.

The solution tank can be filled in two different ways:

1. removing the inlet cap (01) and filling with the aid of a rubber tube

2. using the rubber cap (02); this supports the water hose on its own, but be sure to remove the filler cap

(01) to allow the proper vent of air.

Remove the filler cap (01) and fill with clean water at a temperature not superior to 50C. The amount

inside the tank can be seen by means of the level pipe (03) on the left-hand side at the rear of the machine.

Add the liquid detergent to the tank in the concentration and manner indicated on the detergent

manufacturer's label. The formation of excess foam could damage the vacuum motor, so use only the

minimum amount of detergent that is necessary.

WARNING! The filler cap (01) can be used as dispenser for the detergent to added to

the solution tank; the cap features moulded notches identifying the percentage of

detergent, ranging from a minimum of 0.1% to a maximum of 0.5%.

MACHINE PREPARATION

DIRECTION.".

Table of Contents