Table of Contents
Advertisement
12. Attach the squeegee body to the squeegee connector.
13. Insert the vacuum hose (07) into the sleeve (08) on the squeegee body.
14. If necessary to empty the solution tank, unscrew the tap-filter (10) on the left-hand side of the machine,
and when finished, re tighten.
15. Connect the electrical system connector (05) to the battery connector
16.Insert the key into the main switch block (04) and turn it a quarter turn clockwise (to position I)
17.Remove the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
18.Take the machine to the designated machine storage place.
19. Apply the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
20. Switch off the power supply to the machine's electrical system using the main switch (04) located on
the rear of the machine, turning the key to position "0".
21.Disconnect the electrical connector (05) from the battery connector.
22. Put the machine in rest mode. Using the control handlebar (01) (pushing downwards), lift the rear part
of the machine so that the rear wheel (02) rests on the floor.
WARNING: Park the machine in an enclosed place, on a flat and level surface; near
the machine there must be no objects that could either damage it, or be damaged
through contact with it.
WARNING: Do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake (only for BT versions). In
addition, do not park the machine in open places or on sloping floors.
AT THE END OF WORK
35
Advertisement
Table of Contents
