Table of Contents
Advertisement
9. Turn the cup (09) anticlockwise and remove from the machine.
10. Remove the recovery tank filter (10).
11. Remove the recovery tank from the machine, taking extra care with the drainage hose.
12. Open the recovery tank drainage tube cap (06).
13. Take the machine to the designated place for draining off the dirty water and clean under a jet of
running water, remembering to also clean the insertion nozzle on squeegee body vacuum tube (04)
and the vacuum motor tube (05) carefully.
14. Reassemble all the elements.
47. CLEANING THE SOLUTION TANK
To avoid deterioration of the solution tank and to prevent odours forming, weekly clean of the tank is
recommended, proceeding as follows:
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions BB).
1. Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position "0" (valid for versions B-BT).
2. Make sure the recovery tank is empty, otherwise empty it completely.
3. Disconnect the electrical connector (02) from the battery connector.
4. Engage the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
5. Loosen the solution tank filter cap (04), turning it anticlockwise.
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
6. Remove the filler cap (05) from the solution tank.
7. Remove the quick fill tube (06) from the solution tank.
8. Remove the cover (07) from the quick fill tube and clean under a jet of running water.
9. Rinse the solution tank with a jet of running water.
10. Reassemble all the elements.
WEEKLY MAINTENANCE
44
Advertisement
Table of Contents
