Regulating Machine Direction; Replacing Squeegee Body Rubbers - Ice MTECH 70 D Use And Maintenance Manual

Professional scrubbing machines

Table of Contents

3. Make sure that the main switch (02) is in the "II" position; if not, position it to "II".

4. Put the machine in rest mode. Using the control handlebar (pushing downwards), lift the front part of

the machine so that the rear wheel rests on the floor.

5. Press the dead man's lever under the control handlebar and simultaneously activate the brush release

lever (03) positioned at the rear of the machine. As soon as lever (03) is activated, release dead man's

lever under the control handlebar.

WARNING: If the brush does not release, repeat the operation again until the brush

is released from the brush head.

WARNING: During this operation, check there are no people or objects near the

brush.

6. Remove the old brush and replace with the new one, reading the paragraph

BRUSH (BB

versions)" for carrying out the replacement.

51. REGULATING MACHINE DIRECTION

On the front of the machine, there is a knob (01) which allows users to adjust the direction of the machine.

If the machine tends to veer to the right, the knob must be turned clockwise, whilst if the machine tends to

veer to the left, the know should be turned anticlockwise.

WARNING: Directional operation of the machine should be carried out with the brush

mounted and with a light flow of solution in order to avoid damage to the floor.

The careful cleaning of the whole vacuum unit ensures better drying and cleaning of the floor as well as

greater duration of the vacuum motor.

To detach the squeegee body from its support, proceed as follows:

1. Switch off the power supply to the machine's electrical system using the main switch (01) located on

the rear of the machine, turning the key to position "0" (valid for versions BB).

1. Switch off the power supply to the machine's electrical system using the main switch (01) located on

the rear of the machine, turning the key to position "0" (valid for versions B-BT).

2. Disconnect the electrical connector (02) from the battery connector.

3. Engage the parking brake by means of the lever (03) on the right side of the machine (only for BT

versions).

4. Lower the squeegee body by means of the lever (04) on the back of the machine.

EMERGENCY MAINTENANCE

"ASSEMBLING THE

Table of Contents