Table of Contents
Advertisement
2. Raise the squeegee body from the ground by means of the lever (02) on the back of the machine.
3. Take the machine to the designated place for draining off the dirty water and empty the recovery tank,
read the paragraph
"EMPTYING THE RECOVERY TANK (B-BT
It is good practice when restoring the level of the solution tank to empty the recovery tank through the
special drainage hose (03).
35. OVERFLOW DEVICE (BB VERSIONS)
The machine is fitted with a mechanical device (float) under the recovery tank lid. When the recovery tank
is full, this device shuts off the air to the vacuum motor in order to protect it; the sound of the vacuum motor
will then be deeper.
If this is the case, proceed as follows:
1. Press the button (01), turning it to position "0"; the brush motor and the solenoid valve will cease to
function.
2. Press the button (02), turning it to position "Pos.-02". The vacuum motor will stop working.
3. Raise the squeegee body from the ground by means of the lever (03) on the back of the machine.
4. Take the machine to the designated place for draining off the dirty water and empty the recovery tank,
read the paragraph
"EMPTYING THE RECOVERY TANK (BB
It is good practice when restoring the level of the solution tank to empty the recovery tank through the
special drainage hose (04).
36. EMPTYING THE RECOVERY TANK (B-BT VERSIONS)
To regulate the detergent, proceed as follows:
1. First, take the machine to the designated place for draining off the dirty water.
2. Check that the brush head and the squeegee are raised off the ground; if not, ensure that this is done
before proceeding.
3. Turn the key operated main switch (02) to the "0" position and remove the key from the instrument
panel.
4. Engage the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
5. Disconnect the tube (01) from its seat, unscrew the drainage cap and empty the recovery tank.
6. After emptying the tank, close the cap and insert the tube (01) into the appropriate seat.
WARNING: this operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
37. EMPTYING THE RECOVERY TANK (BB VERSIONS)
To regulate the detergent, proceed as follows:
1. First, take the machine to the designated place for draining off the dirty water.
2. Check that the brush head and the squeegee are raised off the ground; if not, ensure that this is done
before proceeding.
3. Press the button (01), turning it to position "0"; the vacuum motor will stop working.
4. Disconnect the tube (02) from its seat, unscrew the drainage cap and empty the recovery tank.
5. After emptying the tank, close the cap and insert the tube (02) into the appropriate seat.
WORK
versions)" carefully first.
versions)".
33
Advertisement
Table of Contents
