Table of Contents
Advertisement
Operating manual Robot powder spray gun PER-X1
4 Basic Safety Instructions
4 Repair or replacement of devices or parts of devices are only allowed to be performed
outside the hazard area by qualified personnel.
4 Use only WAGNER original spare parts and accessories.
4 WAGNER assumes no liability for changes to the product made by the operating
company without the knowledge of WAGNER. Any adjustments to the documentation
and the market release are the responsibility of the operating company.
4 Only repair and replace parts that are listed in the chapters "Accessories" and "Spare
Parts" and that are assigned to the device.
4 Do not use any defective components.
4 Before all work on the device and in the event of work interruptions:
4 Switch off the energy and compressed air supply.
4 Relieve pressure on spray gun and device.
4 Secure the spray gun against actuation.
4 Observe the operating and service manual for all work.
4.2.8 Protective and Monitoring Equipment
Danger due to removal of protective and monitoring equipment!
Danger to life and equipment damage.
4 Protective and monitoring equipment must not be removed, modified or rendered
unusable.
4 Regularly check for perfect functioning.
4 If defects are detected on protective and monitoring equipment, the system must not
be operated until these defects are remedied.
To prevent electrostatic flashover, the union nut for securing the nozzles is designed in a
certain geometric shape. This shape, together with the shape of the flat jet nozzle or
deflector cone sleeve, prevents the nozzles from coming loose unintentionally (see chapter
Accessories [8 51]).
To ensure safety, only use original WAGNER spare parts!
4.3 INFORMATION ABOUT SAFE DISCHARGES
1
2
3
P_03884
Order number 2444998 | Edition 10/2022
4
15
Advertisement
Table of Contents
