Basic Safety Instructions; Safety Instructions For The Operator; Electrical Devices And Equipment; A Safe Work Environment - WAGNER PER-X1 Translation Of The Original Operating Manual

Operating manual Robot powder spray gun PER-X1
4 Basic Safety Instructions
4 BASIC SAFETY INSTRUCTIONS
4.1 SAFETY INSTRUCTIONS FOR THE OPERATOR
4 Keep this operating manual at hand near the device at all times.
4 Always follow existing regulations concerning occupational safety and accident
prevention regulations.
4.1.1 Electrical Devices and Equipment
Danger of electric shock!
Danger to life from electric shock:
4 Place and operate device in accordance with the existing safety requirements with
regard to the operating mode and ambient influences.
4 May only be maintained by skilled electricians or under their supervision. With open
housings, the mains voltage poses a danger.
4 Operate device in accordance with the safety regulations and electrotechnical
regulations.
4 Do not disconnect any plug connections during operation.
4 Label plug connections with the warning "Do not disconnect when energized".
4 Must be repaired immediately in the event of problems.
4 Decommission if device poses a danger or is damaged.
4 Must be de-energized before work is commenced.
4 Secure the device against being switched back on without authorization.
4 Inform personnel about planned work.
4 Observe electrical safety regulations.
4 Ground all devices to a common grounding point.
4 Only operate the device with a properly installed socket with a protective ground wire
connection.
4 Keep liquids away from electrical devices.
4.1.2 A Safe Work Environment
Danger due to dust formation!
Severe or fatal injuries due to explosion danger or inhalation, swallowing or contact with the
skin or eyes.
4 The floor of the work area must be electrostatically conductive (measurement in
accordance with EN 1081:2018+A1:2020 or EN 61340-4-1:2004+A1:2015).
4 In the spray booth, coating may only be performed with correctly designed and locked
technical ventilation.
4 Make sure that grounding and potential equalization of all system parts is reliably and
permanently in effect and that they withstand the loads to be expected (e.g.
mechanical, corrosion).
4 Make sure that the personal protective equipment (see chapter Personal Protective
Equipment [8 12]) is present and being used.
4 Make sure that all people within the work area wear static dissipative shoes. The
footwear must correspond to EN 20344. The measured insulation resistance must not
exceed 100 MΩ.
Order number 2444998 | Edition 10/2022 11