Per-X1 Single Inside (Si) - WAGNER PER-X1 Translation Of The Original Operating Manual

Operating manual Robot powder spray gun PER-X1
6 Assembly and Commissioning
6.6.2 PER-X1 Single Inside (SI)
P_04917
Assembly:
1. Guide the connection cable as well as the powder and atomizing air hose through the
robot arm and the RSI robot flange.
2. Connect the spray gun to the connection cable, powder and atomizing air hose.
3. Screw the RSI robot flange onto the PER-X1 robot spray gun.
4. Screw the robot spray gun with the RSI robot flange onto the robot arm.
Disassembly:
Note: Disassembly is carried out in reverse order to assembly!
Before replacing the robot spray gun, any powder residue must be thoroughly removed.
The wearing parts in the robot spray gun, marked in the spare parts list with "♦", must be
regularly checked and replaced as necessary.
1. Unscrew the robot spray gun with the RSI robot flange from the robot arm.
2. Unscrew the RSI robot flange from the robot spray gun.
3. Pull the connection cable, powder and atomizing air hose off of the gun.
4. Replace PER-X1 robot spray gun and assemble it again as described in Assembly.
26 Order number 2444998 | Edition 10/2022