Table of Contents
Advertisement
Operating manual Robot powder spray gun PER-X1
7 Operation
Work steps for an example with powder injector as powder conveyor:
1. The atomizing air has to remain open to prevent powder from penetrating into the
atomizing air channels and the cascade compartment during the flushing process.
2. Switch off the powder feed and high voltage generation.
3. If the settings of the feed and dosing air should not be changed, in order to continue
coating with the same powder cloud, remove the powder injector from the injector
connection of the powder tank.
4. When the system is switched on again, no more powder will be delivered.
5. Switch the powder feed on again to blow out any powder remaining in the gun.
6. The powder feed can now be switched off.
7.5.2 Switching Off the Automatic Gun in the Event of Faults or Emergencies
In the event of faults or emergencies, use the emergency stop device to switch off the gun
together with the system. The high voltage and coating material feed are switched off at the
same time.
7.5.3 Pressure Relief / Work Interruption
4 Carry out the work steps in accordance with the chapter on pressure relief in the
operating manual of the corresponding device:
ð If a prompt for pressure relief is given.
ð If coating work is interrupted or stopped.
ð Before the device is externally cleaned, checked or serviced.
ð Before the spray nozzle is installed or cleaned.
7.6 REPRODUCIBLE SETTING OF THE NOZZLE POSITION
P_01671
An adjustment tool is provided for the flat jet nozzle.
It permits turning the flat jet nozzle without damaging the electrodes and without removing
the union nut.
The union nut only has to be slackened.
32
Order number 2444998 | Edition 10/2022
Advertisement
Table of Contents
