Create Cam Data; Memory Configuration Of Cam Data - Mitsubishi Electric iQ-F Series User Manual

3.2

Create Cam Data

Memory configuration of cam data

Cam data is arranged in the following 2 areas.
Memory configuration
Cam storage area
Cam open area
Previously written cam data can be used after turning the power supply OFF by writing data in the cam storage area. Cam
data should be written in the cam storage area for normal use.
It is possible to write directly to the cam open area via buffer memory when registering cam data that exceeds the memory
capacity in the cam storage area, etc. (Page 82 Cam data operation function) However, writing must be executed to the
cam open area every time due to clearing the data at the power supply OFF.
Storage item
Cam data
Cam auto-generation data
Cam data
Details
Data is written by the following
operations.
• Write with the engineering tool
• When executing "write (Cam
storage area)" with the cam data
operation function
Data is written when the cam auto-
generation request is executed. (Cam
auto-generation function)
Cam data is transmitted from the cam
storage area by the following
operations.
• Power supply turn ON
• Write to the cam storage area
• "[Cd.190] PLC READY signal" OFF
to ON
• When specifying the cam open
area with the cam data operation
function
• When executing the cam auto-
generation function
Remark
• Data is preserved even when
turning the power supply OFF.
• Data is lost when turning the power
supply OFF.
• The cam data that is used in cam
control is stored.
3 CAM FUNCTION
3.2 Create Cam Data
3
79