Advertisement
Operating the projector
Learn how to operate the projector and adjust projector settings.
Projector power modes
The CineLife+ projectors track laser operation hours for the laser optical subsystems (LOS) and the
lamp operation hours for xenon lamps.
The projector operates with the following power modes:
Mode
Standby
Standby (IMB On)
Projector on
Light source on
CineLife+ User Guide
020-103073-11 Rev. 1 (05-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
• CineLife+ electronics remain on standby with the light engine off.
• Fans, laser optical sub-systems (LOS) or xenon lamp, and thermo-electric cooler
(TEC) devices are off.
• Integrated Media Block (IMB) is off—IMB automation does not function.
• Fire alarm does not function.
• CineLife+ electronics and the IMB are powered on with the light engine off.
• Power is available to the optional touch panel and laser optical sub-systems
(LOS).
• Power is available to the thermo-electric cooler (TEC) devices; however, the
drivers are disabled.
• Some fans are low speed (depending on projector type).
• Pumps are off.
• Chiller is off (if applicable).
This mode is set from Service Setup > Preferences > IMB.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are off.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
• IMB is on.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are on.
• Fans run at full speed.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
• IMB is on.
14
Advertisement
