Cabinet Setup Shelf Installation - True TBR Series Installation Manual

Cabinet Setup
Shelf Installation
Procedure
1. Hook the shelf clips into the shelf standards. See fig. 1.
2. Push up on the bottom of the clip. See fig. 2.
NOTE: You may need to squeeze or twist the bottom of the
shelf clip for proper installation. Position all four shelf clips
equal in distance from the floor for flat shelves.
3. Ensure the shelf clip is not loose or able to wiggle out of the
shelf standard. See figs. 3 and 4.
4. Place the shelves on the shelf clips with the cross support bars
facing down.
NOTE: Be sure all shelf corners are properly seated.
Installation Tips
• Install all the shelf clips before installing any shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the rear clips before
the front.
– DO NOT use pliers or
WARNING
any crimping tools when installing
shelf clips. Altering shelf clips in any
way can lead to shelving instability.
Shelf Adjustment
Shelving is adjustable for customer application. This cabinet meets
the IEC Shelf Weight Capacity of 47lb/ft2 (230kg/m2).
TEC_TM_043 | REV. F | EN
TBR | TDR SERIES
Fig. 1. Installing top tab of shelf clip.
Fig. 3.
You may need to squeeze or twist
the bottom of the shelf clip to install.
Shelf
Shelf
Clip
03/2/2023
www.truemfg.com
Fig. 2. The bottom tab of the shelf clip
will fit tightly
Fig. 4.
Installed shelf clip..
Shelf
Standards
Shelf
Pillaster
(I-beam)
Page 9 of 40