Cabinet Adjustments, Servicing; Servicing & Replacing Components; Reverse Door Swing - True TBR Series Installation Manual

Cabinet Adjustments, Servicing & Component Replacement
NOTE: Any cabinet adjustments are to be made AFTER the
cabinet has been verified level and properly supported.
Servicing & Replacing Components
• Replace component parts with OEM (original equipment
manufacturer) components.
• Have a licensed service provider service your unit to minimize
the risk of possible ignition due to incorrect parts or improper
service and to ensure the operator's health and safety.
• Unplug the refrigerator/freezer before cleaning or making
any repairs. Setting temperature controls to the 0 position or
powering off an electronic control may not remove power
from all components (e.g., light circuits, perimeter heaters, and
evaporator fans).

Reverse Door Swing

Kit Contents (shipped with cabinet)
• Bottom hinge bracket
• Top hinge bracket
Required Tool(s)
• Phillips screwdriver
• 5/16" socket wrench
• Flat blade screwdriver
NOTE: Make cabinet adjustments after verifying the cabinet is
level and supported properly. The example shown is a left hinge
door changing to a right hinge door.
Procedure
1. Locate and remove the bolts securing the top hinge bracket to
the front of the cabinet base. Remove the bolts. See fig. 1.
2. With the bolts removed, swing the bracket onto the door.
Tilt the top of the door out to provide clearance from the
countertop. Lift the door to disengage it from the top hinge
bracket. See fig. 2.
3. Remove the bottom hinge assembly from the cabinet.
See fig. 3.
Fig. 4a.
Top hinge components.
Page 30 of 40
TBR | TDR SERIES
• Door cam base and riser
• Top hinge bushing
Door Top
Top hinge bracket
and shaft
Top hinge bushing
Door bracket
Fig. 1. Top hinge bolt locations.
Fig. 2.
Remove the top hinge from the unit.
Fig. 3.
Lift the door off the bottom hinge.
Fig. 4b.
Bottom hinge components.
03/2/2023
www.truemfg.com
Door Bottom
Door bracket
Door cam riser
Components not on the door
but included in the assembly.
Door cam base
Bottom hinge bracket
and shaft
P#803294 TEC_TM_043 | REV. F | EN