Table of Contents
Advertisement
Cabinet Setup (cont.)
Air Distributor Manifold & Distributor Cover
A 2-way air distributor manifold is included to allow a single CO₂
supply line to pressurize two kegs. The air distributor is located
behind the distributor cover. To access, lift the cover off the
manifold mounting bracket. See figs. 1 and 2.
Fig. 1.
LIft the distributor cover.
Fig. 2.
The 2-way distributor manifold.
WARNING
when handling filled CO₂ tanks. If unfamiliar
with using CO₂ tanks and/or regulators, seek
information from your local distributor or brewer
representative before proceeding.
Page 12 of 40
– Contents under pressure. Take care
TBR | TDR SERIES
CO2 & Keg Connections
NOTE: CO2 cylinders, regulators, and keg tappers are not
provided by TRUE.
Required Tools
Required tools include (but may not be limited to) the following:
• CO2 Cylinder
• Pressure Regulator
• Tapper
NOTE: Be sure to use hose clamps for all air and beer lines as
applicable.
Procedure
1. Attach a pressure regulator to your CO2 cylinder.
2. Connect the pressure regulator to the distributor manifold.
3. Connect the distributor manifold to your tapper(s).
4. Connect the draft tower beer line(s) to your tapper(s).
5. Attach the tapper(s) to your keg(s).
6. Open the pressure regulator valve and pressurize the system.
NOTE: It requires 1/2 lb (0.23 kg) of CO2 to dispense a half-
barrel of beer at 38˚F (3.3˚C) with 15 psi (1.03 bar) of pressure
on the barrel.
7. Engage your tapper(s)
8. Check all connection points for leaks. If the system leaks, verify
all fittings and clamps are tight and seal correctly.
03/2/2023
www.truemfg.com
P#803294
TEC_TM_043 | REV. F | EN
Advertisement
Table of Contents
