Table of Contents
Advertisement
Installation & Setup
Installation & Setup
The appliance owner is responsible
a Personal Protective Equipment (PPE) hazard
Assessment and to ensure adequate protection during
maintenance and cleaning procedures.
Use appropriate
during installation and servicing.
Take care when moving, installing,
Sharp edges!
cleaning, servicing and maintaining the appliance to
avoid cuts. Be sure to take care when reaching under
the appliance or handling metal components. Keep
fingers out of pinch point areas, such as the space
between appliance doors and surrounding appliances.
Take care closing doors with children nearby.
Risk of electrical shock or burn!
electronic control or setting temperature controls to
the 0 (off) position does not remove power from all
components. Unplug the appliance or turn off the
power supply before installation or servicing.
Tip over hazard!
when uncrating, installing or moving the appliance.
Take appropriate safety precautions. Use of tip over
restraints may only reduce (not eliminate) the tipping
hazard. Never allow children to climb or hand on
drawers, doors or shelves.
Crush or cut hazard!
installing, moving, or servicing the appliance.
Page 10 of 28
WARNING!
for performing
tools, safety equipment, and PPE
Powering off an
Appliance may pose a tipping hazard
Keep clear when uncrating,
MODEL SERIES
Uncrating
• If the appliance is damaged, note all damage on
the delivery receipt, immediately file a claim with
he delivery freight carrier, and contact TRUE.
NOT install the appliance or put it in service.
• If the appliance is laid on its back or side, be sure
to leave the appliance upright twice the time it
has been laying down (up to four (4) hours) before
plugging the appliance into a power source. If
this time exceeds four (4) hours, let the appliance
sit upright for 24 hours before powering the
appliance.
Keys for appliances with door locks are located in the
warranty packet.
Required Tools
Required tools include (but may not be limited to) the following:
• Adjustable wrench
• Phillips screwdriver
06/15/2023
USER ACTION!
NOTICE!
P#975541
truemfg.com
DO
TEC_TM 204 | REV. A | EN
Advertisement
Table of Contents
