Table of Contents
Advertisement
Installation
Uncrating
Tools Required
• Adjustable wrench
• Phillips screwdriver
• Level
The following procedure is recommended for uncrating the unit:
Procedure
1. Remove the outer packaging (cardboard and bubbles or
styrofoam corners and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
NOTE: Move the unit as close as possible to the final
location before removing the wooden skid.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 2.
NOTE: Some models may require removing the front and/or
rear grill to access the shipping bolts.
3. If leveling legs or castors will not be used, remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT lift the cabinet by the countertops, doors,
drawers, or grills.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 3) and see the installation instructions on the
next page.
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks
are located in the warranty packet.
– Units may pose a tipping hazard
WARNING
while uncrating, during installation, or when
moving the unit.
TEC_TM_043 | REV. F | EN
TBR | TDR SERIES
Fig. 1.
Remove the exterior packaging.
Fig. 2.
Shipping bolt locations.
Fig. 3.
When lifting unit, do not use countertops, doors/drawers, or grills
as a lifting point.
03/2/2023
www.truemfg.com
Page 5 of 40
Advertisement
Table of Contents
