Table of Contents
Advertisement
Installation & Setup (cont.)
Shelf Installation
WARNING!
Remember to follow the guidelines below when
loading product:
• When loading, product may NOT block the air
flow from the top (honeycomb) or at the bottom
(stainless steel evaporator cover).
• Product may NOT extend over the front edge of the
shelves.
Cantilever Shelving Installation
Cantilever shelves come packaged inside the unit. Leg leveling
parts may be taped to the top of the shelf packaging. See fig. 1.
Fig. 1. The cantilever shelf components.
Page 18 of 36
AIR CURTAIN
TAC-72
Hook the shelf support tabs into the shelf standard in the rear
corners and middle of the appliance. See fig. 2.
A
B
Fig. 2. Hook the shelf supports into the shelf standards.
12/13/2023
P#975542
truemfg.com
Installation & Setup (cont.)
TAC-48SM-LD
NOTICE ›
For ease of installation, it is recommended that the
lower shelf be installed first.
1. Install the shelf brackets into the shelf standards.
a. Position the shelf bracket in front of the shelf standard.
Raise the front of the bracket up at a 45° angle, to allow
the bracket support tab to slide into the slot in the shelf
standard. See fig. 3.
b. Slide the shelf angle adjustment tab into the shelf standard.
Position the tab in the shelf bracket to support the shelf at
the desired angle.
c. Repeat a and b for the shelf bracket on the other side.
2. Install the shelves onto the shelf brackets.
a. Position the shelf on the shelf brackets. The horizontal bends
on the left and right sides of the shelf should be to the
outside of the brackets.
b. Move the back of the shelf up and back until the front of the
shelf clears the shelf support tab on the shelf bracket.
See fig. 4.
c. Once the shelf has cleared the shelf support tab, slide the
shelf forward until the front of the shelf is under the front
shelf support tab. When installed correctly, the shelf will be
supported between the notched areas in the shelf brackets.
See fig. 5.
d. Repeat a, b, and c for additional shelves.
TEC_TM_086 | REV. C | EN
TEC_TM_086 | REV. C | EN
AIR CURTAIN
Shelf Standard
Bracket Support Tab
Angle Adjustment Tab
Fig. 3. Install the shelf brackets.
Shelf Support Tab
Fig. 4. Install the shelves.
Fig. 5. Correct shelf installation.
12/13/2023
truemfg.com
Page 19 of 36
Advertisement
Table of Contents
