Table of Contents
Advertisement
Cabinet Setup
Curved Glass Deli Case Receptacles
Deli cases are equipped with a service receptacle located on the
upper left of the cabinet rear. Cord and plug included.
WARNING
– DO NOT connect an electrical load
greater than 4.0 amps to this receptacle
Standard Accessories
Stainless Steel Shelf Installation
1. Without disconnecting the elastic tubing, lift each door up out
of its track. Stretch the elastic surgical tubing and set the doors
on each side of the unit.
2. Locate the shelf supports and install the teeth-end into the
stainless pilasters on the interior walls at the desired height
(see fig. 1). Install as matching left and right pairs at the same
height.
3. Position the stainless steel shelf with the product stop towards
the front of the cabinet. See fig. 2.
NOTE: Be sure the side flaps overlap the shelf support (see
fig. 3) and the shelf support tip fits into the front slot of the
shelf (see fig. 4).
4. Plug the shelf light into the receptacle. See fig. 5.
NOTE: Lights will not operate if they are not plugged in.
5. Reinstall the doors.
TEC_TM_122 | REV. A | EN
TCGG
Fig. 1. Hook the shelf supports into the pilasters at the desired height.
Fig. 2. Position the product stop towards
the front of the cabinet.
Fig. 4. Shelf support tip fits into the front slot of the shelf.
Fig. 5. Plug in the shelf light.
03/24/2021
truemfg.com
Fig. 3. Be sure the shelf's side hooks
over the shelf support.
Page 9 of 18
Advertisement
Table of Contents
