Cabinet Setup; Standard Accessories & Shelf Installation - True TDB-24-48-1-G-1-HC Installation Manual

Cabinet Setup

Shelf Installation
Procedure
1. Hook the shelf clips into the shelf standards. See fig. 1.
2. Push up on the bottom of the clip. See fig. 2.
NOTE: You may need to squeeze or twist the bottom of the
shelf clip for proper installation. Position all four shelf clips
equal in distance from the floor for flat shelves.
3. Ensure the shelf clip is not loose or able to wiggle out of the
shelf standard. See figs. 3 and 4.
4. Place the shelves on the shelf clips with the cross support bars
facing down.
NOTE: Be sure all shelf corners are properly seated.
Installation Tips
• Install all the shelf clips before installing any shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the rear clips before
the front.
– DO NOT use pliers or
WARNING
any crimping tools when installing
shelf clips. Altering shelf clips in any
way can lead to shelving instability.
Fig. 1.
Installing top tab of shelf clip.
Fig. 3. You may need to squeeze or twist
the bottom of the shelf clip to install.
Page 10 of 28
U N D E R B A R R E F R I G E R A T I O N
Fig. 2.
The bottom tab of the shelf clip
will fit tightly
Fig. 4. Installed shelf clip..
Shelf
Shelf
Clip
Horizontal Bottle Cooler Bin Divider Installation
Horizontal bottle coolers are shipped with bin dividers in place. To
adjust the spacing, see the instructions below.
NOTE: A divider positioned in front of the mechanical box
requires a specific notch cutout.
Procedure
1. Push the divider towards the rear of the cabinet to release
the front pegs from the front grommeted holes. Dividers are
spring-loaded.
2. Align the front divider pegs with the desired holes and,
starting with the bottom divider pegs, punch through the
interior tape lining of both the top and bottom holes.
NOTE: Front holes are taped over to improve insulation
values.
3. Remove the divider from the front holes. Align the regular and
spring-loaded rear divider pegs with the holes corresponding
to the desired front holes. Then, insert the rear pegs as far as
possible and maneuver the front pegs into place.
NOTE: Divider positioned in front of mechanical box requires
specific notch cut out.
03/1/2023
Pillaster
(I-beam)
P#975552 TEC_TM_114 | REV. C | EN
truemfg.com
Shelf
Standards
Shelf