Table of Contents
Advertisement
Cabinet Setup (cont.)
Overlay Panel Installation (cont.)
Procedure (cont.)
5. Clamp the door and panel. See fig. 6.
NOTE: If the clamp jaws are not padded, insert padding
between the clamp and the overlay to protect the panel's
finish.
6. Fasten the overlay to the door (see fig. 7). Then, remove
the clamps.
NOTE: Be sure the mounting screws are shorter than
the panel width.
7. Mark the drill bits with the measures below. See fig. 8.
a. 3/8" bit at 1/2" (25.4 mm)
b. 17/64" bit at 1-1/8" (28.575 mm)
8. Carefully drill holes for both hinges as described below.
See fig. 9.
a. Drill the 3/8" hinge bushing/cam hole.
b. At the center of the bushing hole, drill the 17/64" hinge
pin hole.
NOTE: Drill the hinge pin hole until the mark reaches
the hinge bracket, not the bottom of the bushing hole.
See fig. 9.
Be sure to drill straight down to prevent
cracking the overlay and/or drilling through
the side.
9. With the existing hardware, install the door handle(s).
See figs. 10 and 11.
10. Install the hinge components.
11. Install the gasket.
NOTE: Verify the gasket is fully seated in the gasket
channel. See fig. 12.
12. Install the door assembly. Verify the door closes correctly
and the gasket seals without gaps. Repeat the process for
each door.
Fig. 10.
Handle screw locations.
Page 20 of 40
TBR | TDR SERIES
Fig. 11.
Installed door handles.
Fig. 6.
Be sure the overlay's center slot is positioned at the top of the door.
Fig. 7.
Cabinet door predrilled hole locations.
1/2"
(12.7 mm)
Bushing /
Cam Hole
Fig. 8.
Mark the hole depths on the drill
bits.
A
Fig. 12.
Pull the side of the gasket to check its installation.
CORRECT; gasket channel is NOT visible.
A:
INCORRECT; gasket channel is visible.
B:
03/2/2023
www.truemfg.com
1-1/8"
(28.575 mm)
Pin Hole
Fig. 9.
Drill the 3/8" hole first.
THEN drill the 17/64" hole.
B
P#803294
TEC_TM_043 | REV. F | EN
Advertisement
Table of Contents
