Starting/Stopping The Cooking Cycle; Cooking Cycle Setting; Cooking Cycle With Time And Cavity Temperature - TECNOEKA EKF 664 TC Original Operating And Instruction Manual

_ Electronic convection oven _ rev. 0 ________________________MODD. EKF 664 TC – EKF 711 TC – EKF 1064 TC

4.3.5 Starting/stopping the cooking cycle

4.3.5 Starting/stopping the cooking cycle 4.3.5 Starting/stopping the cooking cycle 4.3.5 Starting/stopping the cooking cycle
Once you have set the desired cooking parameters, use the "START/STOP"
the relevant cycle.
To stop the cooking cycle at any time, hold the "START/STOP"
seconds.
When a cooking cycle stops (in "manual" mode or in "programmed" mode), an alarm beeps
for 30" and, at the same time, the following message will flash on screen: "END OF
COOKING". COOKING". COOKING". COOKING".
If the key is touched during this time, the SUMMARY SCREEN for the cooking cycle that has
just ended will come back up on the display. The cooking cycle starts again automatically for 1
MINUTE. To extend the cooking time, simply touch the "STEP"
parameter then use the
;
The 30" "end of cooking" beeping alarm can be switched off at any time by touching the
"STEP" "STEP" key or the "START/STOP"
"STEP" "STEP"
The SUMMARY SCREEN for the cooking cycle that has just ended will come back up on the
display.

4.3.6 Cooking cycle setting

4.3.6 Cooking cycle setting 4.3.6 Cooking cycle setting 4.3.6 Cooking cycle setting

4.3.6.1 Cooking cycle with time and cavity temperature

4.3.6.1 Cooking cycle with time and cavity temperature
4.3.6.1 Cooking cycle with time and cavity temperature 4.3.6.1 Cooking cycle with time and cavity temperature
From the "TIME" From the "TIME"
From the "TIME" From the "TIME"
Use the and
TIME ("INF" or in the range from 0h 01' to 9h 59')
Use the "STEP" "STEP"
"STEP" "STEP"
PAUSE (in the range from 0h 01' to 23h 59')
HOLD ("YES" or "NO")
_________________________________________________________________________________________ page 27 _
key to set the desired value.
"START/STOP"
"START/STOP" "START/STOP"
PARAMETER SCREEN PARAMETER SCREEN
PARAMETER SCREEN PARAMETER SCREEN
keys to set the desired value:
key to set the desired option:
EKF 1111 TC – EKF 1664 TC – EKF 2011 TC
"START/STOP"
"START/STOP" "START/STOP"
"START/STOP"
"START/STOP" "START/STOP"
"STEP" "STEP" "STEP"
key.
key to start
key again for a few
"END OF "END OF "END OF
key and select the TIME