Cavity Cooling" Function; Haccp" Function - TECNOEKA EKF 664 TC Original Operating And Instruction Manual

__ TECNOEKA Srl ____________________________________________________ operating and instruction manual _

4.3.8.2 "CAVITY COOLING" function

4.3.8.2 "CAVITY COOLING" function 4.3.8.2 "CAVITY COOLING" function 4.3.8.2 "CAVITY COOLING" function
This function allows you to cool the cooking cavity quickly after finishing a cooking cycle.
Open the oven door (the screen will turn red).
When you touch the
temperature inside the cooking cavity in real time while the function is running.
The "cooling" function can be switched off at any time using the "START/STOP"
alternatively, it will end automatically once the temperature inside the cooking chamber drops
to 45°C.
In both cases, once the function has finished, the warning screen against a red background
appears on the display with the message "door open".
Closing the door calls up the summary screen for the cooking cycle that has just ended and you
can now set a new cycle: use the "STEP"
use the and
product to be cooked inside the oven. To start the cooking cycle, close the door again and press
the "START/STOP" "START/STOP" "START/STOP" "START/STOP"
To set a new cooking cycle with the door open, simply press the "SELECT"
up the summary screen for the cooking cycle that has just ended.
Within 5", use the "STEP" "STEP" "STEP" "STEP"
and keys to select the relevant values. Once you have placed the product to be cooked in
the oven, you can start the cooking cycle by closing the door and pressing the "START/STOP"
key.

4.3.8.3 "HACCP" function

4.3.8.3 "HACCP" function 4.3.8.3 "HACCP" function 4.3.8.3 "HACCP" function
The purpose of the "HACCP" function is to record the operating data of the cooking sessions
performed, monitoring their progress constantly.
The "HACCP" data are recorded on a "USB drive", which must be connected to the relevant
"USB port" on the oven. The USB key is not included but is an optional accessory
_ page 40 _________________________________________________________________________________________
key, the "COOLING" "COOLING" screen will appear showing you the value of the "COOLING" "COOLING"
"STEP"
"STEP" "STEP"
keys to set the relevant values for each: open the door and place the
key.
key to select the parameters to be edited and then use the
key to select the parameters to be edited and then
"START/STOP"
"START/STOP" "START/STOP"
"SELECT" key; this calls
"SELECT" "SELECT"
"START/STOP" "START/STOP" "START/STOP"
key;