Table of Contents
Advertisement
__ TECNOEKA Srl ____________________________________________________ operating and instruction manual _
9.2 Replacing the door seal
9.2 Replacing the door seal
9.2 Replacing the door seal
9.2 Replacing the door seal
The door seal has a rigid edge with 4 clips holding it in place. This edge must be inserted in the
relevant guide found on the oven cavity side.
To replace the seal, simply pull the old one out of the guide (pull firmly near the 4 corners).
Remove any foreign matter from the guide and clip the new seal in place (to make it easier to
fit, we suggest moistening the seal's edge with soapy water).
9.3 Cleaning the fans
9.3 Cleaning the fans
9.3 Cleaning the fans
9.3 Cleaning the fans
Fans must be cleaned at regular intervals with appropriate limescale products. All parts of the
fans must be cleaned carefully, removing any limescale.
To gain access to the fans, simply remove the fan guard after first unscrewing the screws
fastening it to the oven cavity. Once you have finished cleaning, refit the guard by following the
same procedure in reverse.
9.4 Adjusting the handle
9.4 Adjusting the handle
9.4 Adjusting the handle
9.4 Adjusting the handle
If the door handle is not closing properly, check and, where necessary, adjust the position of the
"catch" as follows:
1. With the oven door open, loosen the "catch" fastening screws.
Move the "catch" vertically and fasten it so that, when the door is closed, it fits into the
2.
handle – in the completely open position (horizontal) – without scraping.
3. Following adjustment, the handle should be in the vertical position with the door closed
(the tip of the "catch" should be perfectly horizontal).
9.5 Troubleshooting
9.5 Troubleshooting
9.5 Troubleshooting
9.5 Troubleshooting
Type of fault
Type of fault
Type of fault
Type of fault
Control panel completely
dark
(oven not working)
Cooking cycle set and
"START" key activated:
oven not working
Steam cycle activated: no
steam is generated in the
oven cavity
Door closed: steam
escaping out of seal
Oven not cooking evenly
_ page 48 _________________________________________________________________________________________
Cause of fault
Cause of fault
Cause of fault
Cause of fault
-
Incorrect connection to mains
power supply
- Mains power not on
- Safety thermal breaker tripped
- Fuse protecting the circuit board
(with microprocessor) has blown
- Door open or ajar
- Magnetic sensor damaged
- Incorrect connection to the water
mains
- ON/OFF valve closed
- Water inlet filter clogged
- Water inlet solenoid valve damaged
- Seal not fitted properly
- Seal damaged
- Handle "catch" loose
- One of the motors is jamming or
running at slow speed
- Motors fail to reverse
Corrective action
Corrective action
Corrective action
Corrective action
-
Check mains
connection
-
Restore mains power
-
Call in a qualified engineer
-
Call in a qualified engineer
-
Close the door properly
-
Call in a qualified engineer
-
Check water mains connection
-
Check valve
-
Clean filter
-
Call in a qualified engineer
-
Check how seal has been fitted
-
Call in a qualified engineer
-
Call in a qualified engineer
-
Call in a qualified engineer
-
Call in a qualified engineer
power
supply
Advertisement
Table of Contents
