Fascia Fitting; To Fit The Closure Plate Baffle; To Fit The Fascia - Valor BRAVA 348 Installer And Owner Manual

Before continuing with the installation of this appliance it is important that the
information contained on the back pages of the Owner guide is completed.

9.1 To fit the closure plate baffle.

The closure plate baffle is supplied with the
fire and is intended for use where the height
of the closure plate and sealing tape is
greater than 580mm. When using the baffle
the height of the sealing tape and closure
plate can be extended to a maximum
630mm.
At the rear top corners of the fascia there
are two screws, one at each side.
Loosen the screws but do NOT remove
them.
Locate the baffle onto the screws as in
figure 13. The baffle is angled and should
lean towards the rear of the fire.
Tighten the screws to secure.

9.2 To fit the fascia.

Place the fascia over the engine. Make
sure that the top rear of the fascia
locates fully into the 'U' shaped notch of
the engine back panel (See figure 14).
Fit the control knob firmly on to the
control spindle.
Secure the fascia using the two screws
previously removed. There are two holes
in the fascia. Use the bottom hole.
©
GDC Group Ltd. 2011
INSTALLER GUIDE

9. FASCIA FITTING

Page 24
Figure 13. Closure plate baffle location
Figure 14. Fascia top location