Table of Contents
Advertisement
Table 4
SNC 6101 SCSI Cable Types
From
To
SCSI 1
Library
SCSI 2
Tape
SCSI 3
drive
SCSI 4
Tape
Library
drive
Tape
Tape drive
drive
3
Insert terminators (high-density 68-pin) in all unused SCSI ports on the drives.
4
Double check your cabling, ensuring that cables are correctly routed and adequately secured in place.
Also verify that all devices are correctly terminated.
SCSI cabling can also be verified using the service port (null modem) on the
Note
SNC 6101 during configuration (scsiShow command). Refer to
the SNC 6101
To connect the RJ-45 Ethernet cable to your SNC 6101
These installation procedures connect the Ethernet port used when you are
Note
updating SNC 6101 firmware.
1
Plug one end of your Ethernet cable into the RJ-45 1 port of the SNC 6101 (RJ-45 2 is disabled). Refer
to "Ethernet ports" illustrated in
2
Plug the other end of this cable into your Ethernet LAN. See
Figure 9
Ethernet Cabling for Firmware Installation
3
Provide another Ethernet cable to connect the laptop/desktop to your Ethernet switch.
20
SCSI Cable Required
Universal SCSI cable with a 68-pin high-density
connector at one end and a VHDCI connector at the
other.
Universal SCSI cable with a 68-pin high-density
connector at each end.
on page 22.
Figure 5
on page 17.
To configure
Figure 9
for an example.
Installation
Advertisement
Table of Contents
