Table of Contents
Advertisement
Table 5 7100 Series
SCSI Cabling
Configuration
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
Library Configuration
2/68
4/68
7/68
2/100
4/100
7/100
The following procedure describes how to connect a 4/100 library
to the host when using the default two-wire, four-drive
configuration:
Remove power from the library as follows:
1
Press and release the control panel
a
verify that System Off-line is displayed in the SDA.
At the rear panel, set the
b
position.
Power down all SCSI devices that will be connected on the
2
same bus as the library.
The library uses differential (diff) SCSI
Caution:
connections. If your host adapter is single-ended
(SE) SCSI, you must use a SE-to-diff converter for
proper communications.
Connect the two library-to-host SCSI cables to the host
3
adapters.
Chapter 3 Installing the Library
Connecting the Library to the Host Controller
Default SCSI Wiring Configuration
1-Wire
2-Wire
4-Wire
1-Wire
2-Wire
4-Wire
STANDBY
button to the " 0 " (off)
POWER
button, and
29
Advertisement
Table of Contents
