Optional Component Installation - Oracle X5-2 Installation Manual

Caution -
disable the system or require repair by service technicians, place components on an antistatic
surface, such as an antistatic discharge mat, an antistatic bag, or a disposable antistatic mat.
Wear an antistatic grounding strap connected to a metal surface on the chassis when you work
on system components.
Read the safety information in the Oracle Server X5-2 Safety and Compliance Guide and in the
Important Safety Information for Oracle's Hardware Systems before installing the server.
Caution -
installation.
Caution -
lift and mount this 1 rack unit (1U) server into a rack enclosure when using the procedures in
this document.
Caution -
clearly before, during, and after each step to minimize confusion.
Related Information
"Safety Precautions" on page 41
■

Optional Component Installation

Standard system components are installed at the factory. Optional components that you
purchased independent of the standard configuration are shipped separately, and in most cases
should be installed before you install the server in a rack.
The following optional components can be ordered and purchased separately:
To protect electronic components from electrostatic damage, which can permanently
Deploy the anti-tilt bar or legs on the equipment rack before beginning an
The server weighs approximately 18.0 kg (40.0 pounds). Two people are required to
When completing a two-person procedure, always communicate your intentions

Optional Component Installation

Preparing for Server Installation 25