Gps; Connecting Gps Devices; Activating The Gps Function - HMS Netbiter EasyConnect Series User Manual

GPS

5. GPS

5.1 Connecting GPS Devices


For information on how to power an external GPS device, please refer to the documentation
supplied with the device.
5.1.1 Netbiter EC220
To connect a GPS device to Netbiter
EC220, a 9‐pin male D‐sub connector is
needed.
Pin
2
3
5
5.1.2 Netbiter EC250
To connect a GPS device to Netbiter
EC250, a 9‐pin female D‐sub connector
is needed.
Pin
2
3
5
5.1.3 Netbiter EC350
The Netbiter EC350 has a built‐in GPS receiver. To use the GPS function, connect a suitable
GPS antenna (not included) to the unit.

5.2 Activating the GPS Function

GPS functionality must be activated in Netbiter Argos before it can be used. Instructions on
how to activate the function can be found in the online documentation in Netbiter Argos.
Netbiter EasyConnect Gateway User Manual
Function
Tx (Transmit to GPS)
Rx (Receive from GPS)
Ground
Function
Tx (Transmit to GPS)
Rx (Receive from GPS)
Ground
GND Rx Tx
Tx
Rx
GND
31
Doc: HMSI-168-92 Rev: 3.00