Installation Guide
5.9 Shipping Screws Installation
This procedure provides instructions for securing an Ultrastar Data60 to the rack for shipping.
Before you begin: Complete the instructions in
Table 38: Installation Requirements
Tool(s):
Part(s):
Person(s):
Time:
If the chassis is being installed into a rack that will be shipped fully assembled, you must install
Step 1 :
eight (four per side) of the included M5 x 12mm T15 Flat Head Torx screws into the two brackets
at the front of the chassis in the following locations. These screws should be tightened to
3.38-3.61 Nm / 30-32 in-lbf using a Long T15 Torx Screwdriver. If this chassis will not be installed
into a rack for shipping purposes, skip this step and move on to the next one.
Figure 57: Shipping Bracket Screw Locations
W hat to do next: T he shipping screws are now installed. Proceed to
Drive Installation (page 61)
Long T15 Torx Screwdriver
M5 x 12mm T15 Flat Head Torx screws
1
5 minutes
5. Installation
5.9 Shipping Screws Installation
.
Enclosure Power On (page 69)
.
68