Top Cover Installation And Extension Test - Western Digital Ultrastar Data60 Installation Manual

Installation Guide
5.7 Top Cover Installation and Extension Test
This procedure provides instructions for installing the top cover and performing an enclosure extension test
for an Ultrastar Data60 .
Before you begin: Complete the instructions in
Table 36: Installation Requirements
Tool(s):
Part(s):
Person(s):
Time:
Step 1 : Secure the chassis top cover to the rack using the captive M5 thumb-screws as shown in the
following image. Use a T15 Torx screwdriver, and tighten the screws to 3.38-3.61 Nm / 30-32 in-
lbf.
Figure 46: Cover Retention Screws
Now that the chassis is installed, test the installation by sliding the enclosure in and out of the
Step 2 :
rack a minimum of three times. If the enclosure binds, catches, or displays any incorrect motion or
behavior repeat the installation.
Long T15 Torx Screwdriver
N/A
1
5 minutes
Note: Adjustments of the vertical rack rails may be required to fix any issues that
may occur.

5.7 Top Cover Installation and Extension Test

Cable Installation (page 47)
5. Installation
.
59