Installation Guide
Grasp both handles at the front of the enclosure and pull with even pressure to extend the
Step 3 :
chassis out of the rack until it is stopped by the safety latches. The safety latches will prevent the
enclosure from coming out of the rack completely and the cover will remain in the rack attached
to the rear alignment brackets.
Figure 47: Chassis Handle Operation
Step 4 :
Perform this same action two more times without the drives loaded to make sure the rail kits are
installed properly.
W hat to do next: T he top cover is now installed, and extension of the enclosure for servicing has been
tested. Proceed to
Drive Installation (page 61)
5.7 Top Cover Installation and Extension Test
.
5. Installation
60