Verify - Printronix SL4M Reference Manual

Chapter 2
RFID PGL Commands
NOTE: 1. The <IDF1> usage does not increment the DF1 field. It

VERIFY

IMPORTANT
This command requires the use of the Return Status port. See
"Return Status Port" on page 83.
Purpose
Mode
Format
64
merges the DF1 content into the AF1 field, keeping the
same representation previously defined for IDF1.
2. The use of IAF1 is to print alpha on every label. If AF1 is
used instead, only the first label is printed. The AF1 field is
not incremented either since it is using the result from the
DF1 merge.
3. UNLOCK option is not and will not be supported for PC
field, since PC field works with EPC field (which already
supports UNLOCK option).
Request the printer to send to the host the ASCII
representation of a dynamic field. The dynamic field
could be one of AFn, BFn, or DFn, but cannot be RFn.
CREATE
VERIFY;field; format ;(D) ASCIIheader (D)
[;(D) ASCIITrailer (D)]
VERIFY The command to verify data of a dynamic
field, enter VERIFY;
field The dynamic field AFn, BFn, or DFn that
contains the data to be sent to the host.
format A letter specifying the format of the
outgoing data to be sent to the host.
B – binary, D – decimal, H – hexadecimal,
S – string
Based on the incoming format of the data
field, a format conversion may be
performed if the outgoing format is not the
same. The AFn and BFn format is always
S type. The DFn format could be either B,
D, or H. Due to the possible conversion the
outgoing datastream could be longer than
the incoming one. The maximum length for
the outgoing data is 512 bytes. If the