Display F/W-Ver; Comm Retry - Printronix SL4M Reference Manual

Chapter 2
RFID Menu (SL4M)
Read Tag
IMPORTANT
This menu item does not position the RFID tag over the
coupler. Make sure to position the tag over the coupler to
receive an accurate reading.
This menu item reads the tag in range of the internal RFID coupler
and reports the tag data to the debug port and momentarily displays
it on the control panel's LCD. It is primarily intended for
development verification by checking that the system is working.
Read Tag & Eject
IMPORTANT
This menu item does not position the RFID tag over the
coupler. Make sure to position the tag over the coupler to
receive an accurate reading.
The menu item works exactly the same as Read Tag (above),
except that after the printer reads the tag, it feeds the label to the
next top-of-form.

Comm Retry

This menu item selects the number of automatic (internal) retries
that the printer will attempt on the same tag before declaring a tag
error and performing the Error Handling mode selected (Overstrike,
Stop, or None). The default is 2.

Display F/W-Ver

This menu item displays the reader firmware version on the control
panel's LCD.
Overstrike Style
This menu item selects the style of the overstrike pattern.
The default is Grid.
When it is set to Grid, a grid pattern prints when it overstrikes.
When it is set to Error Type Msg, an error message prints that
indicates which error occurred (see Table 4 on page 45).
44