Printronix SL4M Reference Manual page 65

ASCIIheader
(D)
ASCIITrailer
NOTE: 1. The DFn field must be defined previously in the CREATE
mode before it can be specified in the VERIFY command
otherwise it will be considered as a syntax error and the
VERIFY command will abort.
2. All RFID Read/Write commands are executed first in the
order they appear in CREATE mode, followed by Alpha
and Barcode commands, and finally VERIFY commands.
The VERIFY commands are always executed last although
they may appear before other commands in the CREATE
mode. The reason for this is to make sure the data are sent
back to the host only if other commands are completed and
the form is not aborted.
3. If the data comes from a DFn field, the DFn format is the
original format before any conversion. If the VERIFY
command specifies a different format, the data would then
be converted to the new format. If the data comes from an
AFn or BFn, the original format is S format.
4. 432 in the ~CREATE line specifies a 6 inch label.
Use 144 for 2 inch labels and 288 for 4 inch labels.
format request will result in a datastream
exceeding the maximum length, an error
would be reported.
A mandatory parameter to specify an
ASCII string of characters, which is
followed by the RFID data, to be sent by
the printer to the host.
Delimiter designating the start and end of a
character string. Replace (D) with any
printable character, except the SFCC and
the slash character (/). The string could be
empty, i.e. there are not headers
preceeding the field data.
Optional parameter to append an ASCII
string of characters to the RFID data. You
can insert the LF/CR characters \r\n into
the string.
VERIFY
65