Power States - SMART Board SBID-MX165 Installation And Maintenance Manual

CHAPTER B
REMOTELY MANAGING THE DISPLAY
4. Configure the serial interface settings using the following values, and then press ENTER.
Baud rate
Data length
Parity bit
Stop bit
A command prompt (>) appears on the following line, and the display can now accept
commands from the computer. If the command prompt (>) doesn't appear, press Enter on
your keyboard.
NOTE
If no message appears or an error message appears, the serial interface isn't configured
correctly. Repeat steps 3 and 4.

Power states

The display has the following power states:
Power state Description
ON The display is in normal operating mode.
READY The screen is off, but the display is ready to turn on when:
l
l
l
SOFT OFF (low The screen is in a low power state (soft off)and won't respond to RS-232
power state) commands. Disable Power saving mode to prevent the display from entering
a low power state. See Power saving mode on page 58.
The display turns on when:
l
l
UPDATEON The display is updating firmware. Do not turn off the display.
63 smarttech.com/kb/171288
19200
8
None
1
A user presses the Power button
A user presses the Power button on the remote control.
You send the set powerstate=on command.
TIP
If the set powerstate command returns an "invalid command"
message, add spaces around the operator symbol (=).
A user presses the Power button
A user presses the Power button on the remote control.
on the front control panel.
on the front control panel.