Toner -- Enable Or Disable Ring Tones - Polycom Vortex EF2201 Command List

hook. A different tone is played whenever the auto-hangup feature puts the phone on-hook. This
feature is typically enabled to prevent a caller from entering or exiting a conference unannounced.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01TONEE1 Enable auto entry and exit tones.
T01TONEE0 Disable entry and exit tones.
Toggle enabled status of entry and exit
T01TONEE2
tones.
T01TONEE? Query enabled state of entry and exit tones.

8.114. TONER -- Enable or Disable Ring Tones

This command sets or queries the enabled status of the ring tone feature. If ring tones are enabled, a
ring tone is played whenever there is an incoming ring signal on the connected phone line.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01TONER1 Enable auto ring tones.
T01TONER0 Disable ring tones.
T01TONER2 Toggle enabled status of ring tones.
T01TONER? Query enabled state of ring tones.
Section 6.1 for more information on this type of command.
Status Message
T01TONEE1
T01TONEE0
T01TONEEx, where x is 0 or 1 depending
on the current enabled state of entry and
exit tones.
T01TONEEx, where x is 0 or 1 depending
on the current enabled state of entry and
exit tones.
Section 6.1 for more information on this type of command.
Status Message
T01TONER1
T01TONER0
T01TONERx, where x is 0 or 1 depending on the
current enabled state of ring tones.
T01TONERx, where x is 0 or 1 depending on the
current enabled state of ring tones.