Dspload -- Query Percentage Of Variable Dsp Resources Used; Error -- Enable Or Disable Error Messages - Polycom Vortex EF2201 Command List

Example Description
T01DSPAUTO1 Enable automatic DSPLOAD messages. T01DSPAUTO1
Disable automatic DSPLOAD
T01DSPAUTO0
messages.
T01DSPAUTO2 Toggle automatic DSPLOAD messages.
Query the value of the DSPAUTO
T01DSPAUTO?
parameter.
8.21. DSPLOAD -- Query Percentage of Variable DSP
Resources Used
This command queries the current percentage used of the available variable DSP resources. When this
number reaches 100 percent, no more variable DSP veatures may ben enabled. An 'ERROR#060' will be
generated if a command attempts to exceend 100 percent utilization.
If the feature is enabled, then a DSPLOAD status message will be generated automatically
DSPAUTO
any time the percent utilization changes.
Example Description
Query percentage of variable DSP
T01DSPLOAD?
resources used.

8.22. ERROR -- Enable or Disable Error Messages

This command sets or queries whether or not error messages for non-fatal errors are reported via RS-
232 and the digital bus.
If an error is generated and error messages are enabled, a status message will be automatically
generated of the form ' T01ERROR#xxx', where xxx is a three digit number indicating the error code.
The following table lists the non-fatal error messages that can be generated by the Vortex.
Error Number Description
Unrecognized command.
ERROR#001
Syntax error in command.
ERROR#002
Attempt to change parameter that is locked via
ERROR#004
Attempt to unlock
ERROR#005
or FPLOCK, but invalid password given.
NVLOCK
Status Message
T01DSPAUTO0
T01DSPAUTOx, where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
T01DSPAUTOx, where x is 0 or 1 depending
on the current setting of the DSPAUTO
paramter.
Status Message
T01DSPLOADx, where x is between 0 and 99
and indicates the percentage of the variable
DSP resources being used.
or FPLOCK.
NVLOCK