Peqig -- Set Gain Parameter For Specified Parametric Eq Input Stage - Polycom Vortex EF2201 Command List

For filter types that have a center frequency (e.g., parametric), this parameter specifies the center
frequency. For filter types that have a cutoff frequency (e.g, highpass, lowpass, etc.), this parameter
specifies the cutoff frequency.
This command has the same format and restrictions as the
parameter, the frequency, is specified instead of all the parameters. See the
information. To set the frequency parameter for an output parametric EQ filter, use the
command. To set all the parameters for an output parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example
T01PEQIFT,2,1250
T01PEQIFT,1,?
8.82. PEQIG -- Set Gain Parameter for Specified Parametric
EQ Input Stage
This command sets or queries the gain parameter (in dB) for the parametric equalizer (EQ) filters on
input channel T. Each channel has five bands of parametric EQ that can be independently controlled.
The minimum and maximum values for the gain parameter are -20 and 20, respectively.
This command has the same format and restrictions as the
parameter, the gain, is specified instead of all the parameters. See the
information. To set the gain parameter for an output parametric EQ filter, use the
set all the parameters for an output parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example
T01PEQIGT,2,-20
Description
Set frequency of parametric
EQ on input T, band 2 to
1250 Hz.
Query current frequency
setting of parametric EQ on
input T, band 1.
Description
Set the gain of the parametric
EQ on input T, band 2 to -20 dB.
command except that only one
PEQIA
Status Message
T01PEQIFT,2,1250
T01PEQIFT,1,f, where f is the current setting
of the frequency parameter for the parametric
EQ on input T, band 1. If the frequency
parameter of this filter is set to the same value
given in the example above, then the status
message will be T01PEQIFT,1,1250.
command except that only one
PEQIA
PEQIA
command.
PEQOA
Status Message
T01PEQIGT,2,-20
command for more
PEQIA
PEQOF
command.
PEQOA
command for more
command. To
PEQOG