Redial -- Redial The Last Dialed Phone Number; Ring -- Enable Or Disable Ring Messages; Sggain -- Set Gain Of Signal Generator - Polycom Vortex EF2201 Command List

T01PRESETX18 Execute preset number 18.

8.100. REDIAL -- Redial the Last Dialed Phone Number

Executing this command causes the Vortex to redial the last number. The last number is defined as all
the digits that were dialed since the phone was last taken off-hook. Like the
phone is not already off-hook, this command will take it off-hook automatically.
Example Description
Redial the last dialed phone number.
T01REDIAL

8.101. RING -- Enable or Disable Ring Messages

This command sets or queries the enabled status of the ring message feature. If ring messages are
enabled, a RING status message will be generated each time the connected phone line rings.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01RING1 Enable auto answer mode. T01RING1
T01RING0 Disable auto answer mode. T01RING0
T01RING2 Toggle auto answer mode.
T01RING? Query auto answer mode.

8.102. SGGAIN -- Set Gain of Signal Generator

This command sets the gain of the internal signal generator. The value of SGGAIN specifies the gain in
dB applied to signal generator. A gain of 0 dB produces a signal at nominal level (-20 dB full scale).
This command is an integer command. See
The minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Status messages for all the commands in the preset will
be generated first, followed by the message:
T01PRESETX18
Section 6.1 for more information on this type of command.
Status Message
T01RINGx, where x is 0 or 1 depending on the current state
of auto answer mode.
T01RINGx, where x is 0 or 1 depending on the current state
of auto answer mode.
Section 6.2 for more information on this type of command.
Status Message
command, if the
DIAL
Status Message
T01REDIAL