Peqob -- Set Bandwidth Parameter For Specified Parametric Eq Output Stage - Polycom Vortex EF2201 Command List

T01PEQOAT,2,1,1250,40,-20,1,1
T01PEQOAT,1,?
8.86. PEQOB -- Set Bandwidth Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the bandwidth parameter (in 1/100th octaves) for the parametric
equalizer (EQ) filters on output channel T. Each channel has five bands of parametric EQ that can be
independently controlled.
The minimum and maximum values for the bandwidth parameter are 5 and 200, respectively.
This command has the same format and restrictions as the
parameter, the bandwidth, is specified instead of all the parameters. See the
information. To set the bandwidth parameter for an input parametric EQ filter, use the
command. To set all the parameters for an input parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Set the
parametric EQ on
output , band 2
to the following
parameters: type
= parametric
filter, frequency
= 1250 Hz,
bandwidth = 40
1/100th octaves,
T01PEQOAT,2,1,1250,40,-20,1,1
gain = -20 dB,
enabled = yes,
slope = 1 dB per
octave. The value
of the slope
parameter is
irrelevant for this
type of filter, we
could have set it
to anything.
T01PEQOAT,1,t,f,b,g,s,e, where the
parameters t, f, b, g, s, and e correspond
Query the current
to the current settings of the type,
parameter
frequency, bandwidth, gain, slope, and
settings for the
enabled parameters, respectively. If this
parametric eq
filter was set to the same parameters as
filter on output T,
given in the above example, the status
band 1.
message would be
T01PEQOAT,2,1,1250,40,-20,1,1.
PEQOA
command except that only one
command for more
PEQOA
PEQIB
command.
PEQIA