Faderi -- Set Input Gain Fader; Flash -- Execute Hook Flash - Polycom Vortex EF2201 Command List

T01ERROR0 Disable error messages mode. T01ERROR0
T01ERROR2 Toggle error message mode.
T01ERROR? Query the state of error mode.

8.23. FADERI -- Set Input Gain Fader

This command adjusts the fader gain of the input signals, which on the EF2201 consist only of the input
from the telephone interface. The fader gain is different from the analog gain (GAINI) in that it is done
in the digital domain. The fader gains are intended to be used for volume control.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
this type of command. The minimum and maximum values for this command are -100 and 20,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01FADERIT10 Set fader gain on input T to 10 dB.
T01FADERIT? Query the fader gain on input T .
Set fader gain on all inputs (T) to 6
T01FADERI*6
dB.
T01FADERI*? Query fader gain on all inputs (T).

8.24. FLASH -- Execute Hook Flash

This command puts the phone on-hook and then takes it back off-hook after a delay. The amount of
time between on-hook and off-hook is controlled by the
country to meet each country's specific compliance requirements. If the phone is on-hook when this
command is given, then no action is performed.
Example Description
T01ERRORx, where x is 0 or 1 depending on the current
state of error mode.
T01ERRORx, where x is 0 or 1 depending on the current
state of error mode.
Section 6.3
Status Message
and Section 6.2
Status Message
T01FADERIT10
T01FADERITx, where x is a number between
0 and 30, depending on the current setting of
the fader gain on input channel T .
T01FADERI*è
T01FADERI*x, where x is between ä and ÿ,
depending on the current setting of the fader
gain for the input channel.
setting and has be set for each
COUNTRY
for more information on