Mutei -- Mute One Or More Inputs - Polycom Vortex EF2201 Command List

T01MMUTET,P,1
T01MMUTEWB0,WM0,0
T01MMUTET,P,2
T01MMUTET,P,?
T01MMUTET,*,10
T01MMUTET,*,0
T01MMUTET,*,2
T01MMUTET,*,?

8.71. MUTEI -- Mute One or More Inputs

This command sets or queries the mute status of the analog inputs (only T on the EF2201).
This command is a channel boolean command. See
this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Mute signal path (in main
matrix) from the telephone
input to the P-Bus output.
Mute signal path (in EF Bus
W submatrix) from W bus
signal at device ID0 (WB0)
to W submatrix output 0
(WM0).
Toggle mute status of
signal path (in main matrix)
from the telephone input to
the P-Bus output.
Query mute status of signal
path (in main matrix) from
the telephone input to the
P-Bus output.
Set all crosspoint mutes for
input channel T. Mute the
path from input T to output
T and unmute the path
from input T to output P.
Unmute all crosspoints for
input channel T.
Toggle all crosspoint mutes
for input channel T.
Query all crosspoint mutes
for input channel T.
T01MMUTET,P,1
T01MMUTEWB0,WM0,0
T01MMUTET,P,x, where x is either 0 or 1
depending on the current mute status of the
crosspoint.
T01MMUTET,P,x, where x is either 0 or 1
depending on the current mute status of the
crosspoint.
T01MMUTET,*,10
T01MMUTET,*,00
T01MMUTET,*,ab, where the value of each of
letters (a, b, etc.) is either 0 or 1 depending on
the current state of each of the crosspoint
mutes. If this command was issued after the
example above, then the status message would
be T01MMUTET,*,00
T01MMUTET,*,ab, where the value of each of
letters (a, b, etc.) is either 0 or 1 depending on
the current state of each of the crosspoint
mutes. If this command was issued after the
example above, then the status message would
be T01MMUTET,*,00
Section 6.3 and Section 6.1 for more information on