Macros -- Start A New Macro; Macrow -- Write Macro To Non-Volatile Memory; Macrox -- Execute Macro - Polycom Vortex EF2201 Command List

Example Description
Execute macro number 125 without generating any status
T01MACROQ125
messages.

8.63. MACROS -- Start a New Macro

This command is used to start writing a new macro with a specified macro number. This command is
used in conjunction with the
is sent while another macro is in the process of being written (before the
then the macro in progress will be deleted and the new one will be started.
See the description of the

8.64. MACROW -- Write Macro to Non-Volatile Memory

This command writes the macro that is currently being defined to non-volatile memory. This command
is used in conjunction with
no macro is in progress (i.e., if a
with this command does not match the number of the macro in progress, then an error will be
returned.
See the description of the
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved
each time it is changed. It will retain its value after power-down. Since this command writes to non-
volatile memory, there will be a delay before an acknowledgment is returned.

8.65. MACROX -- Execute Macro

This command executes the macro corresponding to the specified number. The macro must have been
previously defined and stored in non-volatile memory via the MACROS, MACROA, and
commands. If the specified macro is empty, then an error condition of ERROR#070 will be generated.
When the MACROX executes, status messages for all of the commands in the macro will be generated
(unless acknowledgement mode
command, which is exactly the same as MACROX except that status messages are suppressed.
MACROQ
Example Description
T01MACROX125 Execute macro number 125.
8.66. METER -- Select which Signal is Displayed on the Front
and
MACROA MACROW
command for detailed information on creating macros.
MACROA
and
MACROA MACROS
command has not been sent) or if the macro number sent
MACROS
command for detailed information on creating macros.
MACROA
is turned off). The status messages can be suppressed by using the
commands to create a new macro. If this command
to create a new macro. If this command is sent when
Status Message
Status messages for all the commands in the macro will
be generated first, followed by the message:
T01MACROX125
Status Message
T01MACROQ125
command is sent),
MACROW
MACROW