Ahcp -- Enable Or Disable Call Progress Based Auto Hangup; Ahld -- Enable Or Disable Loop Drop Based Auto Hangup - Polycom Vortex EF2201 Command List

Example Description
Set AGC ramp rate on input channel
T01AGCRATET3
T to 3 dB/sec.
Query the AGC ramp rate on input
T01AGCRATET?
channel T.
8.7. AHCP -- Enable or Disable Call Progress Based Auto
Hangup
This command sets or queries the status of the call progress based auto hangup feature. There are two
methods of auto hangup supported: call progress and loop drop. The call progress method listens for
off-hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for a
drop in loop current on the phone line and hangs up the phone if a loop current drop is detected. The
AHCP command controls the call progress auto hangup feature. The
drop auto hangup feature. These two features are controlled and implemented independently.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01AHCP1 Enable call progress based auto hangup mode. T01AHCP1
T01AHCP0 Disable call progress based auto hangup mode. T01AHCP0
T01AHCP2 Toggle call progress based auto hangup mode.
T01AHCP? Query auto hangup mode.
8.8. AHLD -- Enable or Disable Loop Drop Based Auto
Hangup
This command sets or queries the status of the loop drop based auto hangup feature. There are two
methods of auto hangup supported: call progress and loop drop. The call progress method listens for
off-hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for a
drop in loop current on the phone line and hangs up the phone if a loop current drop is detected. The
command controls the call progress auto hangup feature. The AHLD command controls the loop
AHCP
drop auto hangup feature. These two features are controlled and implemented independently.
Status Message
T01AGCRATET3
T01AGCRATETx where x is a number
between 1 and 5, depending on the current
setting of the AGC ramp rate on input channel
T.
Section 6.1 for more information on this type of command.
Status Message
T01AHCPx, where x is 0 or 1 depending
on the current state of the call progress
based auto hangup mode.
T01AHCPx, where x is 0 or 1 depending
on the current state of the call progress
based auto hangup mode.
command controls the loop
AHLD