Sgmute -- Mute Signal Generator; Sgtype -- Set Type Of Signal Produced By Signal Generator - Polycom Vortex EF2201 Command List

T01SGGAIN6 Set signal generator gain to 6 dB.
T01SGGAIN>3 Increase signal generator gain by 3 dB.
T01SGGAIN? Query signal generator gain.

8.103. SGMUTE -- Mute Signal Generator

This command controls the muting of the signal generator.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
T01SGMUTE1 Mute signal generator.
T01SGMUTE0 Unmute signal generator.
T01SGMUTE2 Toggle mute on signal generator.
T01SGMUTE? Query signal generator mute.
8.104. SGTYPE -- Set Type of Signal Produced by Signal
Generator
This command sets the type of signal produced by the internal signal generator. Setting the type to 0
produces white noise, while setting the type to 1 produces pink noise.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description
Configure signal generator to produce
T01SGTYPE0
white noise.
Configure signal generator to produce
T01SGTYPE1
pink noise.
T01SGGAIN6
T01SGGAINx, where x is the new value of
the signal generator gain. If this command
was issued after the example above, then the
status message would be T01SGGAIN9.
T01SGGAINx, where x is the new value of
the signal generator gain. If this command
was issued after the example above, then the
status message would be T01SGGAIN9.
Section 6.1 for more information on this type of command.
Status Message
T01SGMUTE1
T01SGMUTE0
T01SGMUTEx, where x is 0 or 1 depending on the
current state of the signal generator mute.
T01SGMUTEx, where x is 0 or 1 depending on the
current state of the signal generator mute.
Status Message
T01SGTYPE0
T01SGTYPE1