Table of Contents
Advertisement
[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 48) for the operation of the menu screen.
f When the projector is used for the first time
Initial password: Press awsqawsq in order, and press the <ENTER> button.
Attention
f When you select the [SECURITY] menu and press the <ENTER> button, entering a password is required. Enter the preset password and
then continue operations of the [SECURITY] menu.
f When the password has been changed previously, enter the changed password, and press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
[PASSWORD]
The [PASSWORD] screen is displayed when the power is turned on, [INITIALIZE ALL] is executed or [INITIALIZE]
in the [NETWORK/USB] menu is executed. When the entered password is incorrect, the operation will be
restricted to the power standby <v/b> button on the control panel or on the remote control.
1)
Press as to select [PASSWORD].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The [PASSWORD] setting is set to [OFF] by the factory default.
f The security password input when turning on the power is not enabled until turning off the power supply and plugging the power plug into
the outlet after setting it to [ON]. If the entered password is incorrect when the power is turned on, the operation will be restricted to the
power <v/b> button.
[PASSWORD CHANGE]
Change the security password.
1)
Press as to select [PASSWORD CHANGE].
2)
Press the <ENTER> button.
f The [PASSWORD CHANGE] screen is displayed.
3)
Press asqw or number buttons (<1> - <6>) to set the password.
f Up to eight button operations can be set.
4)
Press the <ENTER> button.
5)
Re-enter the password for the confirmation.
6)
Press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f Change the password periodically and make it hard to guess.
f An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
f If numbers have been used for the security password, the security password will need to be initialized again if the remote control is lost.
Consult your dealer for the initialization method.
[TEXT DISPLAY]
Overlap the security message (text) over the projecting image.
1)
Press as to select [TEXT DISPLAY].
78 - ENGLISH
Chapter 4 Settings - [SECURITY] menu
Disables the security password entry.
Enables the security password entry.
Advertisement
Chapters
Table of Contents
