Table of Contents
Advertisement
Prerequisite:
•
The feed dog is lowered.
•
The machine is switched off.
•
The needle and presser foot are removed.
> At the marking on the upper right corner of the stitch plate, push the stitch plate downwards until it tips.
> Remove the stitch plate.
> Place the openings of the new stitch plate above the corresponding guide pins and press down until it
clicks into place.
Selecting the stitch plate in the User Interface
After changing the stitch plate, you can check whether this can be used with the selected needle.
> Tap «Stitch Plate Selection».
> Select the previously fitted stitch plate.
–
If the selected stitch plate is suitable to be used in combination with the needle, sewing can begin.
–
If the selected stitch plate is not suitable to be used in combination with the needle, an error message
is displayed and starting the machine is automatically prevented.
2.11 Threading
Threading the upper thread
Prerequisite:
•
The needle and the presser foot are raised.
•
The machine is switched off.
> Place the foam pad on the spool pin.
> Place the thread spool on the spool pin so that the thread unwinds clockwise.
> Attach the appropriate spool cap.
> Guide the thread in direction of the arrow through the rear thread guide (1) and hold the thread with the
hands so that it is taut and can be inserted into the thread tension.
Sewing Preparation
41
Advertisement
Table of Contents
